Program Charter Universal Remote
In many cases, you can program your cable, satellite or universal remote to control certain functions of your TCL Roku TV. Look for your provider and the remote code from the table below, and use the instructions from your service provider to program your cable and satellite remote.These codes come from the TV remote cable providers. TCL must rely on these companies to provide their codes.
Program Charter Universal Remote To Tv
If your code is not listed here please contact your provider.Note: Not all buttons on your Roku TV remote can be programmed to the buttons on your cable or satellite remote.
Charter Remote Codes List
.Operating Manual For Easy Clicker UR3-SR3 Universal Remote Control, Inc. Www.universalremote.com.Introduction This remote control is designed to operate most Digital and Analog Cable Boxes, as well as TVs, and a VCR or DVD player.
Pair Charter Remote To Tv
Replacing Batteries Before you program or operate the remote control, you must install two new AAA alkaline batteries. STEP1 Remove the battery compartment cover from the back of your remote control.Button Functions Programming the Remote Control.Note: In this section, when you are instructed to press a DEVICE button, that means you should press either the CBL, TV, or DVD button, depending on which device you are programming the remote to operate. A.STEP1 Turn on the equipment that you want the remote control to operate Cable Box, TV and DVD(VCR). STEP2 Press the DEVICE button and the OK/SEL button simultaneously for three seconds. The corresponding device LED will turn on indicating that it is ready to be programmed. The LED will remain on for 20 seconds.STEP2 Press the DEVICE button and the OK/SEL button simultaneously for three seconds. The device LED will turn on indicating that it is ready to be programmed.
The LED will remain on for 20 seconds. The next step must be entered while the LED is on.simultaneously for 3 seconds. The DVD LED will turn on for 20 seconds. The next step must be performed while the LED is on. STEP2 Press the TV button.
STEP3 Point the remote control toward the TV and enter the three-digit code for your TV from the TV codes table.To access the programmed channels, press the MACRO button once. This will bring up the first channel. Press once again and it will bring up the second channel. Press again and it will bring up the third channel. To erase the Macro programming and return to the original function: STEP1 Press the CBL button to select the CABLE mode.Assigning the Channel keys to a Assigning the Channel keys to a ent Device ent Device By default, the CH+, CH-, NUMERIC and LAST keys operate through your Cable Box.